Ethernet ELITE 16 Adapter  (260-5506)     Settings      Faxback Doc. # 5155

1. CONFIGURATION JUMPER

   A. The jumper at W1 will set the adapter's I/O, IRQ, and RAM.
      There are 3 hardware choices:

      1. SOFT

      2. 280.3.D0000 (default)

      3. 300.10.CC000

   B. The SOFT configuration allows other values to be chosen through the
      setup program.  This choice is used when either the default or op-
      tional hardware configuration will cause a conflict with other
      boards or the functioning of the computer.

2. ROM JUMPER
   
   A. W2 should be set to NONE/SOFT if you are not using a ROM device.

   B. Only Boot ROMs v2.0 and later should be used with this adapter
      board.

   C. Correct installation

      1. Carefully insert ROM device into the ROM socket.  Avoid touching
         the pins and align the notch in the ROM device with the notch in
         the ROM socket.

      2. Configure the ROM window size and base address.  Most ROM de-
         vices use 16K of address space.  Move the jumper at W2 to D8000.
         This allows the ROM to respond to addresses in the range D8000 -
         DBFFF.  If that range is occupied, leave the W2 jumper at NONE/
         SOFT and use the software setup program to establish the ROM
         base to another location.  If it is necessary to change the win-
         dow size from 16K to 32K or 64K, you must use the setup program.

(CSS/jlc-03/28/94)