433 DX/T  (259-7702)            OS/2 Drivers            Faxback Doc. # 2340

Located on the SVGA Accelerator OS/2 Drivers diskette is a file
README.TXT. This file will provide additional information regarding the
OS/2 driver options.  To display or print the file, insert the diskette
into Drive A; at the operating system prompt, type a: and press <ENTER> and
then type README or PRINTME and press <ENTER>

OS/2 drivers are provided for Version 1.2 and 1.3 Presentation Manager.
Follow these steps the first time you use the OS/2 display drivers:

Note: If you change the refresh rate or disable and re-enable the SVGA
circuitry, repeat these steps to ensure that OS/2 uses a video mode that is
compatible with the SVGA circuitry and monitor.

1. Make sure the OS/2 SVGA Accelerator drivers diskette is not write
   protected. Then, restart your computer with this diskette in Drive A.
   Follow the instructions on the screen.

   The software records the parameters for the SVGA circuitry and monitor
   selections in the MTABLE.WDC file on the diskette.

2. If OS/2 is not already installed, install it with the standard VGA driver
   packaged with OS/2.
3. Restart your computer with the OS/2 installation diskette in Drive A.
   When the first OS/2 screen is displayed, press ESC to enter the OS/2
   command interpreter.
4. Change to the \OS2\INSTALL directory on Drive C.
5. Run DDINSTAL, and follow the directions on the screen.

(rjs-05/21/93)