Fujitsu M2611T#D/M2612ET/M2613ET/M2614ET:Switch Settings

PCA Layout All configurations marked "*" are default settings

SW1

1.IRQ14/RSVD
   Normal status      Key 1 ON(*),   Key 2 OFF(*)
     Pin 29=Reserved, Pin 31=IRQ 14
   After exchange     Key 1 OFF,     Key 2 ON
     Pin 29=IRQ 14, Pin 31=Reserved
2.SLV/ACT
   Active mode         Key 3 OFF(*), Key 4 ON(*)
   Slave present mode  Key 3 ON,     Key 4 OFF
(Notes)
   This plug should be set in "Active mode" on daisy-chained connection
   of both M261xET.

SW2

1.Master/Slave
   Master drive        Key 1 ON(*)  Key 2 OFF(*)
   Slave drive         Key 1 OFF    Key 2 ON
    Slave side of
    2-drive system
2.1-drive/2-drive
   1-drive             Key 3 OFF(*)
   2-drive             Key 3 ON
3.Write-protect
   Write-enabled       Key 4 OFF(*)
   Write-protected     Key 4 ON
4.IOCHRDY
   27 Pin=Reserved     Key 5 OFF(*)
   27 Pin=IOCHRDY      Key 5 ON
5.ECC Bytes
   4 bytes             Key 6 OFF(*)
   7 bytes             Key 6 ON

Connector CN7

External LED connector
         Pin     Function
         01      LED(V)
         02      LED
(notes) Cable length should not exceed 30 centimetres.

to the table of contents!!